SK0-002試験の対応資格はCompTIA Server+
1. which three should be documented after upgrading a scsi raid controller? (select three)
a. disk utilization
b. installation date
c. adapter baselines
d. location slot of the raid controller
e. status of the adapter card installation
f. raid controller information (warranty, specifications etc.)
answer: bdf
3. which of the following is the functional description of a server connected between two separate ip
subnets?
a. server as a bridge
b. server as a router
c. server as a switch
d. server as a data link
answer: b
4. a company plans to upgrade a network server. before proceeding with the upgrade, the hcl
(hardware compatibility
list) and hardware is checked and necessary backups and documentation are made.
the existing 512 mb of sdram is replaced with 1024 mb. the 10 mbps network card is replaced with a
10/100 pci
network card. when the server restarts, beeps sound and the server does not pass the post.
which of the following is the most likely cause of the problem?
a. the memory is not seated correctly.
b. the network card is not configured correctly.
c. the server does not support 1024 mb of memory.
d. master sdram ecc needs to be enabled in the cmos.
answer:a
5. the latest scsi adaptor card is purchased from a vendor. drivers for the operating system cannot be
obtained. the
scsi adapter card is added to an existing server. upon booting, the operating system does not detect the
card. which of
the following is the most likely cause of the problem?
a. the scsi card is not seated correctly.
b. the termination is incorrectly set on the scsi card.
c. the scsi card is not listed on the operating system hcl (hardware compatibility list).
d. operating system patches were not